England's Stove Works 50-SNC30 Installation & Operation Manual page 24

Illustration 6
DIRECTIONS FOR INSTALLATION OF
(Stove must be cooled and all ashes cleaned out)
* Remove bricks, disconnect flue, and turn stove on its back.
* If you are replacing existing legs or pedestal, disconnect
the existing legs or pedestal.
To install legs:
1. Each leg will fit into a pre-made slot on each corner of the
bottom of the unit.
2. A 3/8" x 1-1/2" Carriage Bolt and matching nut is supplied
with each leg. Fit a leg into a slot, and match the hole on
the leg with the hole in the slot. Attach the legs one at a
time, using the supplied bolts and nuts. Tighten securely.
To install pedestal:
1. Place spacers (provided) between the slots on the unit
and the pedestal base (one spacer will fit on each side of
the pedestal). Match the four holes in the pedestal (2 on
each side) with the holes in the spacers and slots on the
unit.
2. Use the four 3/8" x 1-1/2" Carriage Bolts and nuts
(provided) to attach the pedestal to the base of the stove.
Tighten securely.
* After attaching the legs or pedestal, turn unit upright,
reconnect flue and replace bricks according to manual.
NOTES:
24
LEGS OR PEDESTAL: