Table of Contents
Advertisement
Available languages
Available languages
GB - ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been
prepared for the owner and operators of a JET GH-2040/ 2060/ 2080/ 2640/ 2660/ 2680/ 26120 ZH metal lathe to promote
safety during installation, operation and maintenance procedures. Please read and understand the information contained in
these operating instructions and the accompanying documents. To obtain maximum life and efficiency from your machine,
and to use the machine safely, read this manual thoroughly and follow instructions carefully.
...Table of Contents
1. Declaration of conformity
On our own responsibility we hereby declare that
this product complies with the regulations* listed on
page 2. Designed in consideration with the
standards**.
2. Warranty
The Seller guarantees that the supplied product is free
from material defects and manufacturing faults. This
warranty does not cover any defects which are caused,
either directly or indirectly, by incorrect use, carelessness,
accidental damage, repair, inadequate maintenance or
cleaning and normal wear and tear.
Guarantee and/or warranty claims must be made
within twelve months from the date of purchase (date
of invoice). Any further claims shall be excluded.
This warranty includes all guarantee obligations of
the Seller and replaces all previous declarations and
agreements concerning warranties.
The warranty period is valid for eight hours of daily
use. If this is exceeded, the warranty period shall be
reduced in proportion to the excess use, but to no
less than three months.
Returning rejected goods requires the prior express
consent of the Seller and is at the Buyer's risk and
expense.
Further warranty details can be found in the General
Terms and Conditions (GTC). The GTC can be
viewed at www.jettools.com or can be sent by post
upon request.
The Seller reserves the right to make changes to the
product and accessories at any time.
3. Safety
3.1 Authorized use
This metal lathe is designed for turning and
drilling machinable metal and plastic materials
only. Machining of other materials is not
permitted and may be carried out in specific
cases only after consulting with the
manufacturer.
Never cut magnesium-
high danger to fire!
The workpiece must allow to safely be loaded and
clamped.
2
Advertisement
Chapters
Table of Contents
