Helmet Holder; Sidestand - Yamaha XSR125 Owner's Manual

Instrument and control functions

Helmet holder

3
ZAUM2033
1. Helmet holder
The helmet holder is located under the
seat.
To secure a helmet to the helmet
holder
1. Remove the seat. (See page 3-16.)
2. Hook the helmet onto the helmet
holder, and then securely install
the seat. WARNING! Never ride
with a helmet attached to the
helmet holder, since the helmet
may hit objects, causing loss of
control and possibly an acci-
dent.
[EWA10162]
To release the helmet from the hel-
EAU14314
met holder
Remove the seat, remove the helmet
from the helmet holder, and then install
the seat.
1
3-17

Sidestand

The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
EAU15306
EWA10242