Wiring - WESTECH SeaStar SS1024 Instruction Manual

Step 3: Mark Holes
Use a pencil or pen to mark the four (4) mounting hole locations on the mounting surface.
Step 4: Drill Holes
Remove the controller and drill 4mm holes in the marked locations.
Step 5: Secure Controller
Place the controller on the surface and align the mounting holes with the drilled holes in
step 4.
Secure the controller in place using the mounting screws.

3.3 Wiring

NOTE: A recommended connection order has been provided for
maximum safety during installation.
NOTE: The controller is a common positive ground controller.
CAUTION: Don't connect the loads with surge power exceeding the
ratings of the controller.
CAUTION: For mobile applications, be sure to secure all wiring.
Use cable clamps to prevent cables from swaying when the vehicle is
in motion. Unsecured cables create loose and resistive connections
which may lead to excessive heating and/or fire.
Step1: Battery Wiring
WARNING: Risk of explosion or fire! Never short circuit battery
positive (+) and negative (-) or cables.
6