Mounting - WESTECH SeaStar SS1024 Instruction Manual

3.2 Mounting

NOTE: When mounting the controller, ensure free air through the
controller heat sink fins. There should be at least 6 inches (150 mm)
of clearance above and below the controller to allow for cooling. If
mounted in an enclosure, ventilation is highly recommended.
WARNING: Risk of explosion! Never install the controller in a sealed
enclose with flooded batteries! Do not install in a confined area where
battery gassed can accumulate.
Step 1: Choose Mounting Location
Locate the controller on a vertical surface protected from direct sun, high temperature,
and water. And make sure good ventilation.
Step 2: Check for clearance
Place the controller in the location where it will be mounted. Verify that there is sufficient
room to run wires and that there is sufficient room above and below the controller for air
flow.
150mm(5.9inches)
150mm(5.9inches)
Figure 3-1 Mounting and cooling
5
Warm air
Cool air