Intended Use - Becker Centronic SunWindControl SWC241-II Assembly And Operating Instructions Manual

The transmitter described in these instructions must only be used indoors for
the operation of Centronic-compatible radio drives and radio control units for
sun protection systems.
Attention
A safety-relevant function has been provided for the
threshold controller. Setting the threshold value wrongly can
cause damage to the sun protection system. For that reason,
setting the threshold value for the safety of your sun protec-
tion system should only be done by – or under the instruction
of – a specialist retailer.
•
Please note that radio-controlled systems may not be used in areas with a
high risk of interference (e.g. hospitals, airports).
•
The remote control is intended solely for use with equipment and systems
in which malfunctions in the transmitter or receiver would not pose any risk
to persons, animals or property, or which contain safety devices to elimin-
ate such risks.
•
The operator is not protected from interference from other telecommunic-
ations systems and terminal equipment (e.g. even from radio-controlled
systems which are properly operated in the same frequency range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
•
Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
•
Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
• Note that the range of the radio signal is limited by legis-
lation as well as by design.

Intended use

15 - en