Table of Contents
Advertisement
Display message
Requires
subscription
to Caller ID.
Use
rechargeable
battery.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
The handset display is blank or
dark.
TGH26xC(en)_1224_ver013.pdf
Cause/solution
R You must subscribe to a Call Display service. Once
you receive caller information after subscribing to a
Call Display service, this message will not be
displayed.
R A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 3, 6.
Cause/solution
R Place the handset on the base unit or charger to turn on
the handset.
R Make sure the batteries are installed correctly (page 9).
R Fully charge the batteries (page 10).
R Check the connections (page 9).
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 41).
R The handset is in screen saver mode (page 14). Activate
the handset display again by:
– pressing M
– pressing MOFFN at all other times.
R "LCD backlight" is set to "Off" while on charge.
Change the setting (page 36).
59
Useful Information
N when on a call.
2013/12/24
14:29:41
59
Advertisement
Table of Contents
