Table of Contents
Advertisement
Getting Started
Other settings
Smart function key (
The Smart function key (
on the bottom of the handset and informs you
with its flashing to allow you to activate the
following features by simply pressing this key.
n When the
indicator flashes rapidly,
you can:
– Answer the call (outside call, intercom).
(page 20, 23)
– Stop paging.
– Stop the alarm sound. (page 38)
n When the
indicator flashes slowly in
standby mode, you can:
– Listen to new messages. (page 50)
– Listen to new Voice Mail messages.
(page 57)
– View the caller list when there are
missed calls. (page 44)
To activate these features, their Smart
function key must be "On". (page 14)
Using the Smart function key (
When the
indicator flashes rapidly/slowly,
press M
N.
R The above features can be activated
depending the situation.
R If you answer a call using the Smart
function key, the speakerphone is activated.
R Even if the handset is placed on the base
unit or charger, the feature can be
activated. You can talk or listen to new
messages without lifting up the handset. If
you want to perform further operations, lift
up the handset.
R When the unit has new messages, new
Voice Mail messages, and missed calls, the
unit can be operated to play the new
messages first, play the new Voice Mail
messages next, and then show the missed
calls.
14
TGH26xC(en)_1224_ver013.pdf
Setting the Smart function key
The Smart function key for the following
features must be "On".
key)
– "New message" (Default: On)
– "New VM" (Default: On)
key) is located
– "Missed call" (Default: Off)
The settings can be set for each handset.
1
2
3
Note:
R If the
Dialing mode
If you cannot make calls, change this setting
according to your telephone line service. The
key)
default setting is "Tone".
"Tone": For tone dial service.
"Pulse": For rotary/pulse dial service.
1
2
3
Screen saver mode
The backlight goes dark when on a call or
turns off completely after 1 minute of
inactivity if the handset is not on the base unit
or charger.
Activate the handset display again by:
– pressing M
– pressing MOFFN at all other times.
14
MMENUN (right soft key) #278
MbN: Select the desired setting and press
MSELECTN.
R "
" is displayed next to the selected
features.
R To cancel a selected feature, press
MSELECTN again. "
" disappears.
MSAVEN a MOFFN
indicator flashes when the
handset is not placed on the base unit or
charger, battery consumption is faster than
usual.
MMENUN (right soft key) #120
MbN: Select the desired setting.
MSAVEN a MOFFN
N when on a call.
2013/12/24
14:29:38
Advertisement
Table of Contents
