Jxpn1 Pan Kit - GE ZKD910 Installation Instructions Manual

This kit contains supports and pans to fit your
new Warming Drawer.
This kit is designed to fit both 27" and 30"
wide models. Select the parts for your model
and discard the parts that do not fit.
Parts Included
One Full size pan with Lid, 21" long x 13" wide x 4" deep
Two Half Size Pans with Lids, 21" long x 6-1/2" wide
x 4" deep
Two Quarter Size Pans with Lids, 10-1/2" long
x 6-1/2" wide x 4" deep
1. Remove the packaging and separate parts.
2. Open the drawer fully.
3. Select the side to side rails to fit your
model.
4. Drop a side to side rail (with slots in the
top) into the slots at the rear and one in
the front of the drawer. Note that slots fit
only one way, with the wide interlocking
tabs on the right sides.
5. Drop filler panel into the right side.
27" Models
6. Drop one or two front to back rails into
matching slots.
JXPN1 Accessory
Two sets of Side to Side Support Rails
(one set for 27" and one for 30" wide models)
Front to Back
Support Rails
For All Models
Wide Slots
Towards Rear
30" Models
Pan Kit for Warming Drawer
Filler Panel
27" Models
Drop Rail
Into Small
Slots
Wide Slots
Towards Inside
Small Slots
Towards Front
27"
Models
30"
Models
Filler Panel
30" Models
10