Blade Tracking Adjustment 主旋翼軌跡調整 - THUNDER TIGER Titan x50 Instruction Manual

Blade Tracking Adjustment 主旋翼軌跡調整
CAUTION / 警告
For safety, ensure to keep a safe distance from the helicopter at least 10 meter (30 feet) while making tracking
adjustment.
安全起見，進行主旋翼軌跡調整時，請至少與直昇機保持10米（30呎）的安全距離。
1. Use a color tape at the tip of main blades for tracking
identification easily.
2. Increase the main blade speed to just before the
helicopter lifts-off.
3. Observe which blade appears to be lower than the other,
and increase the pitch of the lower blade one turn of the
Linkage Rod C (refer Page 12) at a time until each blade
runs in track. If both main blades rotate in the same path,
,
it doesn t need to be adjusted.
1. 在主旋翼前端貼上色標可方便辨識軌跡。
2. 提高主旋翼轉速使機體稍懸浮於地面。
3. 觀察兩支旋翼軌跡是否有落差（雙槳），調整軌跡較低旋翼上
的連桿C (參閱第12頁) 長度，一次調整一圈，直至兩支旋翼軌
跡一致。若軌跡一致則無需調整。
CAUTION / 警告
Out of track causes vibration, instability and a loss of power due to additional drag. Please adjust the tracking
repeatedly until the blades are in track properly.
旋翼軌跡落差（雙槳）會造成直昇機震動、不平衡及損失動力。請務必進行調整以使旋翼軌跡精準正確。
All manuals and user guides at all-guides.com
-34-
Linkage Rod C
(refer Page 12)
連桿C (參閱第12頁)
color tape / 色標貼
Out of Track / 雙槳
Adjustment is
necessary.
需要調整
color tape / 色標貼
In Track / 軌跡正確
Adjustment is
unnecessary.
不需要調整