Table of Contents
Advertisement
BLADE TRACKING ADJUSTMENT / 主旋翼軌跡調整
CAUTION / 警告
For safety, ensure to keep a safe distance from the helicopter at least 5 meter (15 feet) while making tracking
adjustment.
安全起見，進行主旋翼軌跡調整時，請至少與直昇機保持5米（15呎）的安全距離。
1. Use a color tape at the tip of main blades for tracking
identification easily.
2. Increase the main blade speed to just before the helicopter
lifts-off.
3. Observe which blade appears to be lower than the other,
and increase the pitch of the lower blade one turn of the
Linkage Rod A (refer Page 10) at a time until each blade
runs in track. If both main blades rotate in the same path, it
doesn , t need to be adjusted.
1. 在主旋翼前端貼上色標可方便辨識軌跡。
2. 提高主旋翼轉速使機體稍懸浮於地面。
3. 觀察兩支旋翼軌跡是否有落差（雙槳），調整軌跡較低旋翼上的
連桿A (參閱第10頁) 長度，一次調整一圈，直至兩支旋翼軌跡
一致。若軌跡一致則無需調整。
CAUTION / 警告
Out of track causes vibration, instability and a loss of power due to additional drag. Please adjust the tracking
repeatedly until the blades are in track properly.
旋翼軌跡落差（雙槳）會造成直昇機震動、不平衡及損失動力。請務必進行調整以使旋翼軌跡精準正確。
Linkage Rod A
(refer Page 10)
連桿A (參閱第10頁)
-28-
color tape / 色標貼
Out of Track / 雙槳
Adjustment is
necessary.
需要調整
color tape / 色標貼
In Track / 軌跡正確
Adjustment is
unnecessary.
不需要調整
Advertisement
Table of Contents
