Configuring The Titan X50 / Titan X50 設定 - THUNDER TIGER Titan x50 Instruction Manual

Configuring The Titan X50 / Titan X50 設定
25.1mm
60mm
55mm
62.2mm
62.2mm
The above pushrod lengths permit 3D flying with the Titan X50.
Use these lengths as a starting point. Pushrod lengths are measured from ball link center to ball link center. Suggested
throttle and collective pitch set up: Idle-up1 is for continuous 3D flying and aerobatics. Idle-up2 is for those who have
very good collective pitch management skills. Use a pitch gauge to check blade angles. It is easier to start setting up
idle-up2 blade pitch angles first. For safety, to inhibit idle-up modes and just use a normal mode setting for a novice is
recommended. The model should hover at around 1550 rpm in normal mode, and flies at around 2000rpm in idle-up1/2.
With 1700 or higher headspeed, the use of carbon/FRP blades is recommended.
以上為 Titan X50 直昇機之3D飛行連桿長度設定值。這些設定值可作為初始設定時之參考標準。
在螺距及油門曲線設定方面，建議設定兩個特技模式。進行連續3D飛行時使用特技模式-1，而進行倒飛練習時則可使用特技模式-2
。此外，建議初學者暫時不要使用特技模式進行練習。
至於轉速的設定方面，建議停懸及特技模式之轉速分別為1550rpm及2000rpm。
建議當轉速高於1700rpm以上時，請將主旋翼更換為玻璃纖維或碳纖維主旋翼。切記！即便使用高性能碳纖維主旋翼，轉速仍有其
上限，請參照旋翼的使用說明，切勿超轉使用。
All manuals and user guides at all-guides.com
35.4mm
55mm
-29-
Normal 正常模式
Idle-up1 特技模式1
Idle-up2 特技模式2
Normal 正常模式
Idle-up1 特技模式1
Idle-up2 特技模式2
Hold 熄火降落
55.1mm
Normal 正常模式
Idle-up1 特技模式1
Idle-up2 特技模式2
Hold 熄火降落
The settings may differ, the table
is for your reference only.
每人操作習慣或有不同，僅供參考。
59.7mm
78.4mm
5-Point Throttle Curves
5點油門曲線
0 35 50 65 100
100 85 60 85 100
100 85 60 85 100
5-Point Pitch Curves
點螺距曲線
35 - 70 - 85
10 - - - 90
0 - - - 100
0 - - - 100
Blade Pitch Angles (degrees)
螺距角度
-4 6 10
-12 0 12
-15 0 15
-15 0 15
Length
measured from
ball link center
to
ball link center
由此連桿頭中心
測量至另一頭
連桿頭中心