Advertisement
ASSEMBLY / OPERATING INSTRUCTIONS
To use the Harness...
To remove harness remove metal rings from harness
3a.
3
end, flatten the butterfly ends and pass through the
slots in the seat (e).
To refit the straps flatten the butterfly ends, pass the
3b.
ends through the slots in the seat (e), then open the
butterfly ends (d) and refit metal rings.
CAUTION! The harness must be used at all times and be
correctly adjusted. Most injuries from high chairs are caused by
falls.
To remove Seat Cushion...
Slide metal rings from harness end.
1a.
1
Feed the harness straps through the slots in seat
1b.
and seat cushion on the back and under the
seat (a) and remove the harness.
Release the seat cushion on either side of the arm
2a.
2
rests by pulling the press studs from the inner armrests
(b).
Lift the cover off the seat (c).
2b.
Refitting the seat cushion is a reversal of this procedure.
2c.
When refitting the harness ensure the butterflies on the
2d.
ends of the harness straps are opened out correctly
(d) and refit metal rings.
To adjust Seat Height and Recline...
1a.
To adjust the height of the seat push in both of
1
the height adjusting locks (a) and simultaneously
raise or lower the seat, releasing both of the locks
at the required height.
NOTE! Do not adjust the height of the seat whilst the child is
seated in the chair.
d
d
a
e
a
9
Advertisement
