Settings for the room temperature
Setting the room temperature
Set the required room temperature at the room tem-
perature controller or higher ranking control unit.
Setting the boiler water temperature (flow temperature)
Set a temperature that allows your rooms to become
sufficiently warm.
Factory setting: 75 °C
Setting range: 20 to 81 °C
Note
Your contractor can change the setting range. For this,
consult your contractor.
Tap the following on-screen buttons:
1. If required,
for the home screen
Setting "Operating program" for central heating
Enable the "Operating program" for central heating.
The setting is required only where one of the following
operating programs is set:
"Only DHW heating"
"Standby mode"
Tap the following on-screen buttons:
1. If required,
for the home screen
Stopping central heating
Disable the central heating "Operating program".
This setting is only necessary if the "Operating pro-
gram"
"Heating and DHW" or
Tap the following on-screen buttons:
1. If required,
for the home screen
2.
for "Operating program"
The set "Operating program" is highlighted.
Single boiler constant control: Central heating
2.
3.
4.
2.
3.
4.
For information on the operating programs, see
page 15.
3.
"Heating" is set.
4.
Operating instructions for room temperature
controller or higher ranking control unit
/
for "Set boiler water temperature"
/
for the required value
to confirm
or
for "Operating program"
The set "Operating program" is highlighted.
Select "Heating and DHW" or
set central heating.
to confirm
"Only DHW"
or
"Standby mode" (frost protection for the boiler
and DHW cylinder is enabled)
to confirm
"Heating" to
21