Displaying actual values
Use
/
to scan the following actual values subject to
the system equipment level:
Note
■
The flashing sensor symbol in the system scheme
shows the position of the actual temperature.
KOL
Collector temperature in °C (standard display)
–
TSPU
DHW temperature in °C
–
■
S3
Thermostat temperature in °C,
–
■
temperature at any additional connected sensor that
may be connected
n1%
Solar circuit pump speed
–
■
n2%
Operating condition of the actuator at relay
–
■
output R2
hP1
Hours run of the equipment at relay output 1
–
■
hP2
Hours run of the equipment at relay output 2
■
–
KWh
Amount of heat in kWh, if the heat meter is
–
■
enabled
MWh
Amount of heat in MWh, if the heat meter is
–
■
enabled
Note
Add the values for MWh and kWh together.
Resetting hours run and amount of heat
Whilst the value is displayed, press the following keys:
1. OK "SET" flashes. Value 0 appears.
2. OK to confirm
Scanning options
5