Table of Contents
Advertisement
Heat Shield Installation
The fireplace comes with two heat shields. The heat
shields are necessary for the safe fireplace operation. The
cabinet heat shield is mandatory for all installations, install
it as follows:
1.
The fasteners come pre-installed in the
shield; use a 1/4" socket to remove.
2.
Place heat shield underneath the cabinet
lip; resecure fasteners to install.
3.
(Situational) For later use, install the vent heat
shield above first wall pass-through. This only
applies to "up and out" venting configurations.
10 |
Unpacking and Initial Setup
Leg Height Adjustment
(Optional) Urbana units have adjustable legs and can
raise the height an additional 3" (76mm) in 1/2" (12.7mm)
increments. This may be desired depending on the install
configuration. Adjust as follows:
1.
With help, gently lay the unit on its
back to access the adjustable legs.
B
A
A
B
2.
Use a 3/8 socket with 6" extension (minimum) to
access fasteners. Remove side fasteners (Labeled A).
3.
Remove end fasteners (Labeled B)
4.
Adjust legs to desired height ensuring all 4
legs are equal. *Legs adjust in 1/2" increments*.
5.
Reinstall fasteners and bring unit to its feet.
B
A
A
B
Advertisement
Table of Contents
