Setting The Set Ip Address Option - Cabletron Systems IRM-3 User Manual

Chapter 4: Local Management
Ethernet Address
Displays the Ethernet address of the IRM3 in a hexadecimal format
(XX-XX-XX-XX-XX-XX).
IP Address and Set IP Address
Displays the current IP address of the IRM3.
Set Current Date
Displays the current date setting at the IRM3.
Set Current Time
Displays the current time setting (in 24 hour format) at the IRM3.
Set Device Lock
Displays the lock status of device. This can be set as either LOCKED or
UNLOCKED. This option enables/disables the source address security
for the IRM3. When enabled (LOCKED), the option prevents any new
source address access to the IRM3 through the station port. If the address
is not already in the source address database for that port, then the port is
turned off.
Set Refresh Time
Displays refresh time for the local console in seconds. The valid range is
from 2 to 99.

4.6.3 Setting the Set IP Address Option

To set the Set IP Address Option, perform the following steps:
1. Using the arrow keys, highlight the Set IP Address field.
2. Enter the IP address into the field in dotted quad notation
(XXX.XXX.XXX.XXX, where XXX is a value between 0 and 255).
The valid range is from 0.0.0.1 to 255.255.255.255.
3. Press RETURN. If an illegal IP address was entered in step 2, the error
message "Illegal Information Entered" appears on the screen.
4. Using the arrow keys, highlight the SAVE SETUP option at the
bottom of the Setup screen.
5. Press RETURN. The message "Modified screen Information Has
Been Saved!" appears on the screen.
Page 4-20 IRM3 User's Guide