Connecting To The Network Through The Aui Port - Cabletron Systems IRM-3 User Manual

3.5.1 Connecting to the Network Through the AUI Port

Connect to the network through the AUI port by performing the following
steps:
Be sure to disable the SQE test function on the transceiver you
!
connect to the IRM3 AUI port. Failure to do so will result in
improper operation of the IRM3. Refer to the applicable
CAUT ION
transceiver manual.
1. Attach an external transceiver to the segment to which the AUI port
will be attached. Refer to the applicable transceiver manual.
2. Attach the female end of an AUI cable, no more than 50 meters in
length, to the transceiver.
3. Attach the male connector on the AUI cable (Figure 3-5) to the AUI
port on the IRM3.
4. Move the slide latchon the AUI port to secure it to the lock post on the
AUI connector.
.
IRM3 User's Guide
Figure 3-5 Connecting to the AUI Port
Connecting the IRM3 to the Network
SLIDE LATCH
SLIDE LATCH
AUI PORT
AUI PORT
AUI CONNECTOR
AUI CONNECTOR
0494107
Page 3-9