Chapter 3 Installing The Irm3; Unpacking The Irm3 - Cabletron Systems IRM-3 User Manual

This chapter provides the instructions needed to install and verify the
proper operation of the IRM3 into a network. The information in this
chapter pre-supposes that the previous sections have been completed
properly.
To install and test the IRM3 perform the following:
• Unpack the IRM3
• Set and verify the IRM3 jumper settings
• Install the IRM3 into an MMAC chassis
• Perform pre-installation checkout
• Connect to the network through either of the following:
- AUI port
- Fiber Optic port
• Perform installation checkout
• Connect UPS (if required)

3.1 UNPACKING THE IRM3

Before installing the IRM3, visually inspect the module. To unpack the
module, proceed as follows:
1. Remove the shipping material covering the IRM3 in the shipping box.
2. Carefully remove the module from the shipping box. Leave the
module in its conductive bag until you are ready to install it. Save the
shipping box and materials in the event the unit has to be reshipped.
3. Visually inspect the module. If you see any damage, contact Cabletron
Systems Technical Support immediately.
IRM3 User's Guide
CHAPTER 3
INSTALLING THE IRM3
Page 3-1