V-fit MCCT-2 Manual page 19

Assembly
5
i. Connect the Footplate Bars (25 L /R ) to the crank arms using 1 x Hex Bolt (9) ,
1 x Spring Washer (6), 1 x Flat Washer (10) through the Footplate Support Bar(25
L/R), then fit 1 x M19 Wave Washer (13) with 1 x S13 Round Cap (8) into the
crank arms for each side
ii. Fit the Dual Action Handlebar (15L/R) into the appropriate side of the main frame.
Secure the Bushings (14) and M19 Wave Washers (13) onto the axle and tighten with 1 x
D-Flat Washer(11), 1 x M8 Flat Washer(10), 1 x M8 Spring Washer(6),1 x M8 x 20mm
Hex Bolt (9), then attach the S13 Cap (8) on the end of the Dual Action Handlebar(15 L/R)
for each side.
iii. Attach the 4 x S17 Round Caps (16) to the both ends of the joints of Footplate Support
Bar (25 L/R) and Dual Action Handlebar(15 L/R). Attach the 2 x S17 Round Caps (16) to the
end of Footplate Support Bar (25 L/R).
iv. Insert the Saddle Post (87) to the Main Frame (66) using 1 x M16 Adjustment Knob
(85). Adjust the height of Saddle Post (87) allowing for a slight bend of the knee when the
pedal is at its lowest position.
11
13
10
9 6
8
15L
16
16
69
14 13
70
14
16
16
25L
30
10
9 6
8
8
9
6
10
11
15R
16
16
85
66
13
36
36
13
87
25R
8
9
6
10
30
Page 19