Graco EM5 Instructions-Parts List Manual page 9

Selecting Dispensing Options
This is the procedure for setting or changing the resettable total and the units of measurement.
1. If the display is asleep, wake it up by pressing any button on the keypad.
2. To enter the dispensing options menus, press and hold the Reset and Total buttons simultaneously for
five (5) seconds.
The first menu is the Resettable Total menu, which is described in the first subsection below. You can move
through the menus by pressing the Reset button. The value that is displayed when you leave each menu is the
value that gets stored.
Resettable Total
In this menu, you can reset the resettable total to zero
or leave it unchanged. The resettable total
accumulates until the next time it is manually reset.
1. If you have not already entered the dispensing
options menus, do steps 1 and 2 in Selecting
Dispensing Options above.
2. With R–TOTAL blinking and the current resettable
total displayed, as shown in Fig. 5, do ONE of the
following two options:
D
Press the Total button.
The resettable total is set to zero, and 00000
GAL or 00000 LITERS is displayed.
You can press the Total button again to toggle
between zero and the previously displayed
resettable total. To lock in the displayed value
and advance to the Units of Measurement
menu, press the Reset button.
OR
D
Press the Reset button.
The currently displayed value is stored, and
the display advances to the Units of
Measurement menu.
Fig. 5
Setup
GAL
R-TOTAL
TI0272
Units of Measurement
In this menu, you can set the units of measurement to
quarts, gallons, pints, or liters.
1. If you have not already entered the dispensing
options menus, do steps 1 and 2 in Selecting
Dispensing Options above.
2. Press the Reset button. QTS, GAL, LITERS, or
PTS will blink to indicate that you are in the
Units-of Measurement menu.
3. With QTS, GAL, LITERS, or PTS blinking, as
shown in Fig. 6, do ONE of the following two
options:
D
Press the Total button.
Each time you press the Total button, the
display scrolls to the next unit of
measurement. To lock in the new unit of
measurement, press the Reset button, and the
display advances to the dispense mode.
OR
D
Press the Reset button.
The displayed unit of measurement is retained,
and the display advances to the dispense
mode.
Fig. 6
GAL
TI0272
309142 9