Select Com Port; Desktop Icons - Rabbit RabbitCore RCM2300 Getting Started Manual

C-programmable module

Hide thumbs Also See for RabbitCore RCM2300:

Table of Contents

Distributor of Digi International: Excellent Integrated System Limited

Datasheet of 101-0453 - MODULE RABBITCORE RCM2300

3.3.3 Select COM Port

Dynamic C uses a COM (serial) port to communicate with the target development system.

The installation allows you to choose the COM port that will be used.

The default selection, as shown in the example above, is COM1. You may select any avail-

able port for Dynamic C's use. If you are not certain which port is available, select COM1.

This selection can be changed later within Dynamic C.

NOTE: The installation utility does not check the selected COM port in any way. Speci-

fying a port in use by another device (mouse, modem, etc.) may cause temporary prob-

lems when Dynamic C is started.

Once your installation is complete, you will have up to three icons on your PC desktop, as

shown below.

One icon is for Dynamic C, one opens the documentation menu, and the third is for the

Rabbit Field Utility, a tool used to download precompiled software to a target system.

Getting Started Manual

Table of Contents