Toshiba RUAGP Series Original Owner's Manual page 30

Circuit information screen
Refer to the table below for the items and content of display information.
Item
UC
Circit
EWT
MWT
LWT
H press
L press
Cds. T
Ecpt. T
Dsch.T
Suct. T
Coil 1
Coil 2
LQT
COMP
FAN
Time
Count
UC operation screen
• Use the
displayed.
• Each time you press
(A→B→C→D). Use the
displayed information item.
Unit
─ Indicates the selected UC number
─ Indicates circuit
°C Indicates the inlet water temperature
°C Indicates the centre water temperature
°C Indicates the outlet water temperature
MPa Indicates the high pressure
MPa Indicates the low pressure
°C Indicates the condensing temperature
°C Indicates the evaporation temperature
°C Indicates the discharge gas temperature
°C Indicates the suction gas temperature
Indicates the pipe temperature of the air heat exchanger (heat pump only)
°C
When viewed from the controller side, the left side is 1 and the right side is 2
°C
Displays "---" when a cooling-only unit is not installed
°C "---" display
ON: Compressor operation
─
OFF: Compressor stopped
rpm Displays the fan rotation speed
h Displays the operation hours
Times Displays the number of startups
• Use the
displayed. You can only switch between "Run/Stop" and "Mode"
in the case of "Unit".
• Press
press
the cursor, select "OK" and press
wish to make a change, select "BACK" and press
the "UC operation" screen without making a change.
Refer to the table below for the items and content of display
information.
Item
Remote/Unit
Run/Stop
Mode
and buttons to switch the UC ("1 to 16")
, you can switch the displayed circuit
and
Description
and buttons to switch the UC ("1 to 16")
or to select the item you want to change then
. The confirmation screen appears. To change it with
Description
"Remote" or "Unit"
"Run" or "Stop"
"Cool" or "Heat"
- 28 -
buttons to switch the
to change. If you do not
to return to