Control Box Layout Diagram - Toshiba RUAGP Series Original Owner's Manual

Control box layout
The layout of the control boxes in the module is as shown below.
The power supply control box contains a power supply switch, module controller (*typical model only), unit
controller and CPU control board.
Each of the inverter boxes contains two compressor (PWM) control boards. Each of the EEV boxes contains one
EEV board.
Note 1) Pump inverter box is limited to integrated inverter pump only.
Note 2) The heater box is limited to 50HP, 60HP (Powerful heating type) only.
Note 3) The relative humidity sensor box is limited to 50HP, 60HP (Powerful heating type) including MC only.
Pump Inverter Box
(Note 1)
EEV Box
Inter-module control circuit cable access

Control box layout diagram

BOX Layout Diagram
Heater Box
(Note 2)
(Water spray system is omitted)
Relative Humidity Sensor Box
(Note 3)
Power supply control box
Power supply cable access
(Ø80 mm hole)
External operation circuit - cable
(2 positions)
- 14 -
Fan Reactor Box
Cooling Fan
Inverter Box (Back Side)
(Circuits C, D)
Inverter box (front side)
(Circuits A, B)