Binding And Fail Safe - HPI Racing Venture Instruction Manual

Binding and Fail Safe

Programming a receiver to recognize the code of only one specific transmitter. Binding and fail-safe is pre-set from the factory.
Caution
1
In France, choose France mode. Otherwise, choose normal mode.
Wählen Sie in Frankreich den Frankreich-Modus, sonst den nor-
malen Modus.
2
Place the transmitter and the receiver close to each other (within one meter).
Turn the power switch on the transmitter to the ON position.
3
Press and hold the receiver setup button,
then turn the power switch to the ON position.
The re-ceiver LED will flash quickly. Release
the setup button after 1 second.
4
Press and hold the binding button on the transmit-
ter for 1 second until the LED on the receiver is
continuously lit.
Fail Safe Setup
Caution
If you change transmitters or add a receiver, you must re-bind before operating your vehicle.
1
Hold the button down.
1
After 1 Seconds
P.34
France mode
Normal mode
ON
2
ON
Refer to page 34 for fail safe setup.
Adjustment tool
3
LED
After 1 Seconds
2
LED
LED continuously lit.