Receiver Connections; Overheat Protection - HPI Racing Venture Instruction Manual

Hide thumbs Also See for Venture:
Table of Contents

Advertisement

Receiver Connections

1146
FIREBOLT 15T MOTOR (540 TYPE)
104105 HPI SF-10W
Steering Servo
Attention
Do not make sharp bends or cut the
antenna.

Overheat Protection.

When the internal temperature of the ESC is higher than a factory preset threshold for 5 seconds, the ESC will reduce and will cut off the output power.
Once the Overheat Protection is activated, the throttle repeats turning on and off quickly and acceleration becomes erratic. Stop driving immediately and solve
the problem by referring to the Troubleshooting guide. Do not drive the R/C car until the LED turns off. Allow the Speed Controller to cool down for 15 minutes.
The Overheat Protection function will turn off and you can drive the R/C car again.
Throttle Signal loss Protection
The ESC will cut off the output power if the throttle signal has been lost for 0.1 second.
The "Fail Safe" function of the radio system is strongly recommended to be activated.
Red
Red
Black
Schwarz
Noir
Black
Schwarz
Noir
CH2:
Antenna
For transponder or other accessories
114712 SC-3sWP2
Electronic Speed Controller
Receiver Switch
:CH1
116504
HPI RF-40WP
Receiver
101929
PLAZMA 7.2V 2000mAh NI-MH BATTERY PACK
LED
:CHB
CH1: Steering Servo
CH2:
Electronic Speed Controller
For transponder or other accessories
CH3:

Advertisement

Table of Contents
loading

Table of Contents