Card Cage Expansion Module Power Supply; Required Tools; Replacing A Card Cage Expansion Module Power Supply - HP E Series User Manual

4. If power was removed to the library, turn on the library main power switch.
5. Close the back door of the library.
The power supply replacement procedure is complete.

Card cage expansion module power supply

Part number
Location
Characteristics
Function
Power supply

Required tools

A #1 Phillips screwdriver is required for this procedure.

Replacing a card cage expansion module power supply

To remove the power supply:
1. Identify the power supply to be replaced.
2. Use a #1 Phillips screwdriver to loosen the captive screws in the black ejector handle at one end and
the screw at the other end.
3. Pull the power supply out of its slot.
WARNING!
To install the replacement power supply:
1. Hold the power supply with its ejector handle on the left.
2. Slide the power supply into the card cage slot.
3. Tighten the ejector handle screw and the mounting screw on the other end.
The power supply replacement procedure is complete.
375816-001
Bottom of the card cage expansion module
•
Hot-swappable
•
3U x 8HP size with two LEDs
Provides up to 150 W to card cage
The power supply can be hot.
Enterprise Modular Library E-Series user guide
10471
91