Interface Controller Locations - HP E Series User Manual

Hide thumbs Also See for E Series:

Table of Contents

Identify the proper slot in the card cage for the e2400-FC 2G interface controller. One must be

installed in the base module card cage, and up to three can be installed in the card cage expansion

module (see

Interface controller cards

Figure 29

Interface controller locations

TIP:

A step stool can be helpful to reach the interface controller slot in the base module card cage

located near the top of the library rack.

Using a #1 Phillips screwdriver, remove and discard a slot cover for each interface controller needed

for installation.

With the ports labeled TD# (where # denotes port numbers 0 though 3) to your left as you face the

back of the library, slide the controller into the card cage slot. Move the ejector handles inward to

fully seat the card.

Using a #1 Phillips screwdriver, tighten the ejector handle screws.

NOTE:

Cabling is performed in the next section,

Installing the Library

Figure

29).

"Cabling the

library" on page 43.

10461

Table of Contents

Ad560–96002