Troubleshooting - Electrolux EHF6343FOK User Manual

24 www.electrolux.com

7. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
The Automatic Heat Up
function does not oper-
ate.
You cannot activate the
outer ring.
The sensor fields be-
come hot.
Problem Possible cause
The appliance is not con-
nected to an electrical
supply or it is connected
incorrectly.
You touched 2 or more
sensor fields at the same
time.
The STOP+GO function
operates.
There is water or fat
stains on the control pan-
el.
You put something on
one or more sensor
fields.
You put something on
the sensor field
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting
is set.
You decreased the heat
setting from .
The cookware is too
large or you put it too
near to the controls.
Remedy
Check if the appliance is
correctly connected to the
electrical supply (refer to
connection diagram).
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Touch only one sensor
field.
Refer to the chapter "Daily
Use".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
.
If the cooking zone oper-
ated sufficiently long to be
hot, speak to the service
centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Start from
crease the heat setting.
Activate the inner ring first.
Put large cookware on the
rear cooking zones if nec-
essary.
and only in-