If the sample tests positive for How A Heat Pump Works ............1 sanitizer, call Aquatherm for service at: 239-482-0606. If the test is negative, the water is probably harmless condensation. Heating Quick Start & Stop ..........2 - 3 Or, as an alternate method, shut the heat pump off, leaving the circulation Heater Controls ................4...
(With heating indicator light illuminated, a 9°F to 12°F difference is typical.) a like-new appearance with only an occasional wash down and—if so desired—a If not, contact Aquatherm for service at: 239-482-0606. But first, be sure all quick waxing. air coil surfaces are free from obstructions– low roof overhangs, landscaping, walls, fences, etc., can restrict air flow.
POOL / SPA selector key to select POOL or after the installation of the heater. SPA. Call Aquatherm Customer Service at 239-482-0606 B. Position water valves to flow water from the pool or spa, through the for recommendation of service company in your area.
Page 6
BY APPROXIMATELY 4 MINUTES. tors, more frequent service may be necessary. For service plan information, please see: Planned Maintenance Program, later in this section, or contact Aquatherm 4. Program Filter Pump Run Time: Customer Support at: 239-482-0606 Most pool/spa systems utilize a timer or multifunction controller to manage filter pump run times.
HEATING TIPS HEATER CONTROLS Heating in Cooler Weather... Appearance may vary by model Late night and early morning, generally being the coolest times of the day, are least efficient for heating. For most efficient heating operation, heat pumps should be timed to operate during the warmest, daylight portions of the day.
Heat pumps contain no owner-serviceable components. Owner- initiated adjustments, beyond the controller “LOC” code, must 12” 12” FRONT not be attempted. If adjustments are deemed necessary, the owner should contact installing dealer or Aquatherm Customer 36” FRONT Support at 239-482-0606. 6’ 2’’...
• Before calling for service, always check the filter, the pump basket, and water either “1” or “0”. Selecting “0” will allow the keypad to remain unlocked. valve positions. If the problem persists, please call Aquatherm at: 239-482-0606 Selecting “1” will enable the User Lock Code option. Then, to enter a lock...
1. Disconnect all electrical power to the heater; turn OFF circulating pump. 3) In addition, all other settings are returned to the factory defaults. If an exter- nal controller is in use, contact Aquatherm Heat Pumps (888-297-3826); ask 2. At the two (2) connection unions, disconnect the plumbing to the heater for assistance with re-configuring the controller for use with an external con- (removal is counter- clockwise).