Table of Contents
Advertisement
Before Assembly
WARNING
1. Take a few minutes to familiarize yourself with the parts and hardware included with your product.
2. Assembly may require two people.
3. Check the frame for any damage and check any wiring (if present) for rips or tears. If you detect damage, rips, or
tears, please contact our Customer Support Team before beginning any assembly.
4. Make sure all the hardware needed is included.
5. It is very important to follow the assembly instructions correctly and to make sure all parts are attached correctly and
firmly tightened when the assembly process is complete.
6. Parts that are not tightened correctly will seem loose and can cause irritating noises and will cause damage to the
equipment.
PLEASE NOTE
: Many of the parts and hardwares listed on the parts list are already pre-assembled or
installed on the unit.
Nylon Lock Safety Nuts
1. It is only necessary to tighten the bolts and nuts to "finger tight" during the assembly process. This will make it
easier to complete certain steps by allowing more tolerance for all the parts to fit properly.
2. Do not tighten all the nuts onto the bolts securely until after you have completed assembly of your product.
3. Use wrenches, pliers, or ratchet and sockets to tighten the bolts and nuts.
4. The Nylon Nut should thread onto the Hex Bolt until the end of the Hex Bolt has passed through the Nylon insert
inside the Nut. Please follow this guideline everytime you see this Nylon Nut icon throughout the assembly steps.
Tools Required For Assembly
Ruler (with both Metric and English measurements)
QTY: 1
Adjustable or flat wrenches
QTY: 2
QM894
Tool
Description/Purpose
Use to measure the length or size of hardware including
bolts to ensure you are using the correct part.
Use to securely install parts including nuts and bolts.
Page 3
Advertisement
Table of Contents
