Table of Contents
Advertisement
Assembly STEP 5
Remove the three Washers (#10) and three Nuts (#11) that
Hardware Required
are pre-assembled on the Seat (#9). Then, attach the Seat
(#9) to the Seat Tube (enhanced) (5E) and secure it with three
Washers (#10) and three Nuts (#11) that were previously
removed.
Attach Bellows (#12A) to the Seat Tube (enhanced) (#5E) as
shown in illustration below.
#11 Nylon Nut (M8)
#10 Washer (M8)
Insert the Seat Tube (enhanced) (#5E) into the opening of the
[3 pieces]
[3 pieces]
post that is protruding from the Main Frame (#1B) a minimum
of 4 inches to engage the lowest hole. Please ensure that the
hole on the Seat Tube (enhanced) (#5E) is facing the same
side as the hole located on the Main Frame (#1B) and
insert the Knob (#17) through the Main Frame (#1B) post and
through the hole on the Seat Tube (enhanced) (#5E). Please
refer to the illustration below.
#17 Knob (M12)
Always ensure that the Knob (#17) is securely tightened
[1 piece]
and engaged through the hole on the Main Frame (#1B) and
thehole setting most comfortable to you on the
Seat Tube (enhanced) (#5E) for your safety.
E
1B
QM894
Page
13
Advertisement
Table of Contents
