Table of Contents
Advertisement
Assembly STEP 4A
Remove the two Special Washers (#29), two D Shape
Washers
(#15), two Washers (#72), two Spring Washers
(#14), and two Bolts (#13) that are pre-assembled on the
Handlebar Axle (#16) Set them aside close by as they will
be used in this step.
Insert the Handlebar Axle (#16) through the Main Frame
(#1B), making sure the Handlebar Axle (#16) is centered.
If you encounter too much friction, try using WD40 or
Vaseline as a lubricant.
Next, on the right side, slide one Special Washer (#29) on
Handlebar Axle (#16) followed by Right Handlebar (#4RA)
and secure with one D Shape Washer (#15)*** [please see
close-up diagram/note below], one Washer (#72), one Spring
Washer (#14) and one Bolt (#13). Repeat this process on
the left side using Left Handlebar (#4LA).
Linkage (#6R). With the help of an assistant, on the
right side as shown in drawing below, insert one Bolt (#18)
through the Right Handlebar (#4RA) followed by one Washer
(#19) and then the Bushing (#34) of Right Linkage (#6R).
Secure these together from the other "inner" side of Right
Linkage (#6R) using one other Washer (#19) and one Nylon
Nut (#20). Repeat this process on the left
side with the Left Handlebar (#4LA).
QM894
4LA
1B
Hardware Required
#13 Bolt (M10x18 mm)
[2 pieces]
#20 Nylon Nut (M8)
[2 pieces]
,
#15 D Shape Washer (M10)
[2 pieces]
#29 Special Washer
[2 pieces]
[***When assembling D Shape Washer (#15), please ensure
of Handlebar Axle (#16) as marked in close-up diagram below.]
4RA
#18 Bolt (M8x43 mm)
[2 pieces]
#14 Spring Washer (M10)
[2 pieces]
#19 Washer (M8)
[4 pieces]
#72 Washer (M10)
[2 pieces]
Page
11
Advertisement
Table of Contents
