Gigabyte MD50-LS0 User Manual page 24

12) SATA0/SATA1/SATA2/SATA3/SATA4/SATA5
(SATA 6Gb/s Connectors/SATA1 Support SATA DOM Function)
13) SSATA0/SSATA1/SSATA2/SSATA3 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and
1.5Gb/s standard. Each SATA connector supports a single SATA device.
Please see page 34 for SATA DOM jumper setting.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives
are configured, the total number of hard drives must be an even number.
• A RAID 10 configuration requires four hard drives.
(Note) When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of
the RAID configuration may vary depends on the devices are connected.
14) SAS0/SAS1/SAS2/SAS3/SAS4/SAS5/SAS6/SAS7 (SAS cable connectors)
The SAS connectors conform to SAS 6Gb/s standard. The SAS0/1/2/3/4/5/6/7 ports can be activated
by using Gigabyte extension card.
SAS4
SAS0
SAS5 SAS1
SAS6 SAS2
SAS7 SAS3
Hardware Installation
SATA1 SATA0
SATA3 SATA2
Normal Mode:
SATA5 SATA4
Pin No. Definition
SSATA1
SSATA0
1
SSATA3
SSATA2
2
3
4
5
6
7
- 24 -
7
1
SATA DOM Mode:
Pin No. Definition
GND 1
TXP 2
TXN 3
GND 4
RXN 5
RXP 6
GND 7
Pin No. Definition
7
1 GND
2 TXP
3 TXN
4 GND
5 RXN
1
6 RXP
7 GND
GND
TXP
TXN
GND
RXN
DEBUG
PORT
RXP
P5V