In-Band Access - Edge-Core ECS3810-26T Installation Manual

I -B A
N AND CCESS
You can access the management agent in the switch from anywhere within the
attached network using Telnet, a Web browser, or other network management
software tools. However, you must first configure the switch with a valid IP
address, subnet mask, and default gateway. If you have trouble establishing a
link to the management agent, check to see if you have a valid network
connection. Then verify that you entered the correct IP address. Also, be sure
the port through which you are connecting to the switch has not been disabled.
If it has not been disabled, then check the network cabling that runs between
your remote location and the switch.
C
AUTION
Telnet sessions. If the maximum number of sessions already exists, an
additional Telnet connection will not be able to log into the system.
The management agent can accept up to four simultaneous
:
A
– 55 –
| Troubleshooting
A
PPENDIX

In-Band Access