Maintenance - Ariens GRAVELY Sno-Thro 834035 Owner/Operator & Parts Manual

3. Set engine speed to full throttle after auger and
impeller are rotating.
NOTE: Full throttle is recommended whenever
throwing snow.
While operating Sno-Thro, attachment lift lever should
be placed all the way forward in its "FLOAT" position.
Ariens Dealers will provide any service or adjustments
which may be required to keep your unit operating at
peak efficiency.
WARNING: AVOID INJURY. Read and
understand Maintenance and Service Safety
Rules in Safety section before attempting any

maintenance.

MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance that should be performed on a regular
basis. More frequent service may be required.
MAINTENANCE SCHEDULE
Daily
Service Performed
Check Fasteners
Check Auger
Gearcase Lubrication
General Lubrication
SERVICE POSITION
Place unit on a flat level surface. Tip unit forward onto
front of Impeller housing for service. Assure unit is
secure and will not tip over. Strap and clamp onto
bench if needed.
CHECK FASTENERS
Make sure all hardware is tightened properly.
CHECK AUGER GEARCASE
IMPORTANT: Proper oil level must be maintained.
Gear cases are filled to the correct level at the factory.
Unless there is evidence of leakage, no additional
lubricant should be required. Check for evidence of
leakage every 25 hours of operation.
To ensure adequate lubricant level:
1. Remove filler plug (Figure 15). Lubricant must be
at least up to bottom of lubricant filler hole with
unit resting on a level-surface.
MAINTENANCE
Every Every
Yearly
5 hrs. 25 hrs.
•
•
•
IMPORTANT: Run attachment a few minutes after
throwing snow to prevent Sno-Thro freeze-up.
After operation, position deflector to its highest position
and lock. This is to prevent snow and ice from
accumulating and stopping deflector movement.
2. Add lubricant if required. Allow oil to drain to level
of plug and replace plug.
3. Use only Ariens special gear lubricant L-2 (Part
Number 00008000).
LUBRICATION LOCATIONS
IMPORTANT: Wipe each fitting clean before and after
•
lubrication.
IMPORTANT: DO NOT allow grease or oil to get on
belts.
NOTE: Apply Sten Mix Hi-Temp Grease or equivalent
to the lubrication fittings. Order P/N: 00036800 - Three
Pack of 3 oz. cartridges or 00036700 - 10 pack of 14
oz. cartridges.
Sno-Thro should be lubricated at beginning of season
or every 25 operating hours. See Maintenance
Schedule.
• Grease auger shaft (Figure 16).
NOTE: To grease auger shaft, remove shear bolt nuts,
and shear bolts. Turn auger on shaft while applying
grease at zerk fittings. Replace shear bolt per
instructions in Shear Bolt Replacement.
• Grease end of spool for chute control crank (there
is no lube fitting).
• Grease carriage frame.
• Oil discharge chute base between chute ring and
chute clamps.
13
1
1. Auger Gearcase
2. Filler Plug
Figure 15
2
OTt0561