Summary of Contents for Ariens GRAVELY Sno-Thro 834035
Page 1
Sno-Thro ® Owner/Operator & Parts Manual Models 834035 S/N-000120 and up 836011 S/N-000231 and up 03689900A 12/03 Supersedes 03689900 Printed in USA...
The contents will provide you with safety affect the performance, durability, or safety of this unit instructions for the safe use of your unit during normal and may void the warranty. Ariens disclaims liability for operation and maintenance. any claims or damages, whether warranty, property...
5. Review Limited Warranty Policy. 6. Fill out Original Purchaser Registration Card and return the card to Ariens Company. SAFETY SAFETY ALERTS SAFETY DECALS AND LOCATIONS Look for these symbols to point out ALWAYS replace missing or damaged Safety Decals.
Page 5
used with Sno-Thro, see Sno-Thro owner’s manual for Avoid sharp edges. Sharp edges can cut. Moving parts can cut off fingers or a hand. requirements. ALWAYS keep hands and feet away from all rotating ASSEMBLY SAFETY RULES parts during operation. Rotating parts can cut off body parts.
Page 6
Never leave a running unit unattended. ALWAYS shut off engine before leaving unit. ALWAYS remove key to prevent unauthorized use. Never carry passengers. Hazardous Slopes DO NOT operate on steep slopes. DO NOT clear snow across the face of slopes. Keep all movement on slopes slow and gradual.
ASSEMBLY PREPARE TRACTOR WARNING: AVOID INJURY. Read and WARNING: Shut off and remove ignition key, understand Assembly Safety Rules in Safety disengage PTO switch (off) and set parking section before proceeding. brake prior to installation. TOOLS REQUIRED 1. Remove all other attachments to tractor. Refer to the Owner/Operator manuals provided with the •...
Page 8
IMPORTANT: Install pivot frame mounts as shown NOTE: DO NOT loosen screw holding cable in place. (Figure 5). Holes 1. Chute Crank Spool 3. Tapping Screw 2. Cable Clamp 4. Chute Clamp 4.17 Figure 6 OTt0622 3.50 2. Install the discharge chute onto Sno-Thro housing.
Page 9
4. Connect lift links to lift arms and Sno-Thro housing. Secure with washers and cotter pins (Figure 9). 1. Lift Link 4. Lift Arm 2. Washer 5. Sno-Thro Housing 3. Cotter Pin Figure 9 OTt2052 5. Assemble carriage frame to pivot frame using (2) 5/8 x 1.50 bolts and (2) 5/8 nuts (Figure 10).
7. Remove bolt from carriage frame. Install tension 9. Attach rear end of lift tube to the actuator lever spring from idler arm to carriage frame (Figure with clevis pin and hair pin (Figure 11). 10). 10. Slide lift lever onto pivot rod in the carriage frame. 8.
Page 11
Control Brackets 2. With rear latch pins locked out, raise rear of carriage frame and then secure to rear hanger 1. Secure control bracket support to tractor frame brackets with latch pins (yokes straddle hanger with .375-16 x .75 capscrews and .375-16 brackets) (Figure 14).
Page 12
PTO is engaged (On). Refer REMOVE ATTACHMENT to Service Manual or see your Ariens Dealer for WARNING: Raise attachment, stop engine, adjustment or correction of improper interlock function.
Every Every of plug and replace plug. Daily Yearly Service Performed 5 hrs. 25 hrs. 3. Use only Ariens special gear lubricant L-2 (Part Check Fasteners • Number 00008000). Check Auger • LUBRICATION LOCATIONS Gearcase Lubrication IMPORTANT: Wipe each fitting clean before and after General Lubrication •...
Figure 16 OTt0581 OTt0541 SERVICE AND ADJUSTMENTS 2. Adjust runners by inserting a spacer of desired thickness under center of scraper blade, loosen WARNING: AVOID INJURY. Read and hardware, slide runners to flat surface (Figure understand Maintenance and Service Safety 17).
Length added to tractor 31" Impeller Diameter 14" Auger Diameter 16" SERVICE PARTS Be sure to always use genuine Ariens parts to keep your Sno-Thro running like new. Part no. Description 51001500 Shear Bolt Service Assembly (Ariens) 051663 Shear Bolt Service Assembly (Gravely)
(90) days after date of purchase, and Ariens Company will repair or replace any such part or accessory free of charge, except for labor, during that period.
Page 29
Ariens Company Gravely A Division of Ariens Company 655 West Ryan Street P.O. Box 157 Brillion, WI 54110-0157 920-756-2141 Fax 920-756-2407 www.ariens.com or www.gravely.com...