Safety - Ariens GRAVELY Sno-Thro 834035 Owner/Operator & Parts Manual

5. Review Limited Warranty Policy.
6. Fill out Original Purchaser Registration Card and
return the card to Ariens Company.
SAFETY ALERTS
Look for these symbols to point out
important safety precautions. They mean:
Attention!
Personal Safety Is Involved!
Become Alert!
Obey The Message!
The safety alert symbols above and signal words below
are used on decals and in this manual. Read and
understand all safety messages.
DANGER: IMMINENTLY HAZARDOUS
SITUATION! If not avoided, WILL RESULT in
death or serious injury.
WARNING: POTENTIALLY HAZARDOUS
SITUATION! If not avoided, COULD RESULT
in death or serious injury.
CAUTION: POTENTIALLY HAZARDOUS
SITUATION! If not avoided, MAY RESULT in
minor or moderate injury. It may also be used
to alert against unsafe practices.
NOTATIONS
NOTE: General reference information for proper
operation and maintenance practices.
IMPORTANT: Specific procedures or information
required to prevent damage to unit or attachment.
PRACTICES AND LAWS
Practice usual and customary safe working
precautions, for the benefit of yourself and others.
Understand and follow all safety messages. Be alert to
unsafe conditions and the possibility of minor,
moderate, or serious injury or death. Learn applicable
rules and laws in your area. Always follow the practices
set forth in this manual.
REQUIRED OPERATOR TRAINING
Original purchaser of this unit was provided with
instructions for safe and proper operation by the seller.
If unit is to be used by someone other than original
purchaser (loaned, rented or sold), ALWAYS provide
this manual and any needed safety training before
operation.

SAFETY

SAFETY DECALS AND LOCATIONS
ALWAYS replace missing or damaged Safety Decals.
Refer to Figure 2 below for Safety Decal locations.
1
1 & 2. DANGER!
Keep clear of auger while engine is running
Read Owner/Operator Manual.
• Allow operation only by properly trained
adult, never children.
Stop engine and remove ignition key prior to
leaving operator's position for any reason.
• Read manual prior to servicing.
• Keep all controls, guards and safety devices properly
serviced and functional.
Rotating parts! Stop engine and remove key
before clearing. High speed impeller rotates
below discharge opening. Wait for all
moving parts to stop before removing
clogs or servicing.
3. WARNING
Factory wheel weights and/or weight bucket must be
4
2
WARNING
Factory wheel weights
and/or weight bucket
must be used with Sno-
Thro, see Sno Thro
owners manual for
requirements.
Figure 2
3
078578