Viessmann VITODENS 200-W Installation And Service Instructions Manual page 49

Coding level 2
(cont.)
Coding in the delivered condition
6E:50 No display correction for outside
temperature.
76:0 Never adjust
7E:0 One boiler connected to the flue
system (single connection)
80:6 A fault message is issued if a fault
is present for at least 30 s.
81:1 Automatic summer/wintertime
changeover
82:0 Never adjust
88:0 Temperature displayed in °C (Cel-
sius)
8A:175 Never adjust
8F:0 All controls active
90:128 Time constant for calculating the
adjusted outside temperature
21.3 h
93:... Never adjust
94:0 Without OpenTherm extension
95:0 Without Vitocom 100 communica-
tion interface, type GSM
96:... Minimum burner output dependent
on the specifications of the boiler
coding card
99:0 Never adjust
Possible change
54:2 With Vitosolic 200 (automatic recog-
nition).
54:3 No function
54:4 With solar control module SM1 with
auxiliary function, e.g. central heat-
ing backup (automatic recognition)
6E:0 Display correction
to
6E:49
6E:51 Display correction +0.1 K to +5 K
to
6E:100
7E:1 Several boilers connected to one
shared flue system (multiple connec-
tions)
80:0 Immediate fault message
80:2 Minimum fault duration until fault
to message occurs, adjustable from
80:199 10 s to 995 s; 1 step
81:0 Manual summer/wintertime change-
over
81:2 Use of the radio clock receiver (au-
tomatic recognition).
81:3 With LON communication module:
Control unit receives the time.
88:1 Temperature displayed in °F (Fah-
renheit)
8F:1 All controls disabled
8F:2 Only standard settings can be con-
trolled
90:1 Subject to the set value, the flow
to temperature is adjusted quickly (low
90:199 values) or slowly (high values) when
the outside temperature changes;
1 step
94:1 With OpenTherm extension (auto-
matic recognition)
95:1 With Vitocom 100 communication in-
terface, type GSM (automatic recog-
nition)
96:... Minimum burner output adjustable
to from ... to 100 % of the rated heating
96:100 output
Codes
5 K to 0.1 K
– –
≙
5 s
≙
10 min
49