Chevrolet Captiva Owner's Manual page 163

Chevrolet Captiva Owner Manual (GMNA-Localizing-MidEast LHD-
14860584) - 2021 - CRC - 5/18/20
4. Connect the jack rocker to the jack.
5. Rotate the rocker clockwise to allow the
jack to rise slowly and ensure that the
jack head is firmly pushed into the lifting
position.
6. After ensuring that the jack is in the
correct position, continue turning the
rocker until the tire is about 3 cm off the
ground.
7. Place the spare tire at the vehicle
bottom near the wheel to be replaced to
prevent the vehicle from suddenly
slipping.
8. Remove the wheel nuts completely.
9. Remove the wheel to be replaced.
10. Install the spare tire on the wheel hub.
11. Install all of the wheel nuts and tighten
them by hand.
12. Rotate the jack rocker counterclockwise
to lower the vehicle to the ground
stably.
13. Tighten the wheel nuts in the order
1-4-2-5-3 as shown in the figure with a
torque of 100 130 .
14. Put the flat tire in the spare tire storage
location and secure it properly. Put tools
back in the tool kit and secure them.
Vehicle Care
Caution
Incorrect wheel nuts or improperly
tightened wheel nuts can cause the
wheel to come loose and even come off.
This could lead to a crash. Be sure to use
the correct wheel nuts. If you have to
replace them, be sure to get new original
equipment wheel nuts. Stop somewhere
as soon as you can and have the nuts
tightened with a torque wrench to the
proper torque specification. Tighten the
wheel nuts to torque specification of
100 130 .
During the entire process of the vehicle
being lifted by the jack, ensure that the jack
is placed vertically and no slipping occurs.
Do not lift the vehicle to a height that
exceeds the necessary height for wheel
replacement.
Check the spare tire regularly to ensure that
it can be used safely in case of emergency.
Repair any flat tire that has been taken off
the vehicle as soon as possible.
163