KI Toggle EL Assembly Instructions Manual

Motor-Operated Furnishing
-FOR COMMERICAL USE ONLY-
M6 x 35
M8 x 12
socket head button-head
cap screw machine screw
Figure 1
ATTENTION: Following assembly,
prior to being placed into service.
table to malfunction.
Table "Zero Setting" Press and hold the Up button for
:
two seconds then release. Next, press and hold the Down
button until table has reached its lowest position then release
Down button. Then, press the Down button again and hold for
approximately 10 seconds. The table now re-set at its "Zero
Setting" position and is ready to operate.
Assembly Instructions
Dual Motor Height-Adjustable Base, Model EL
Detail A
M6 x 35
socket head
cap screw
foot
leg-to-leg
spanners
set screw
holes
cross-support
tube
table must be "zero set"
Failure to do so can cause
Toggle Tables
®
January 2019
adjustable
"
3
#10-24 x / glide
8
Torx head
screws
non-locking
caster
locking
caster
foot
adjustable
glide
foot
plate
leg
column
M8 x 12
button-head
machine screw
mounting
flange of
motor housing
end-support
tube
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
1. Carefully remove contents from
packaging, set out on a soft, clean
surface and refer to Figure 1
to identify the parts required for
assembly.
2. Position two cross-support tubes
(with mounting tabs down and
facing inward), and one
end-support tube out as illustrated.
Place a leg column assembly over
the three tubes, aligning all six
mounting holes on the flange of the
column with the mounting holes on
the three tubes. Using six
M8 x 12 button head machine
screws torqued to 9.5 ft/lb, secure
the flange of the leg column to the
three base tubes (Figure 1).
3. Mount the foot to the leg column
by first positioning a plastic foot
plate over the mounting location
on the leg column. The plastic foot
plate should be oriented so the
raised flange faces down on the
leg to nest the foot plate in place.
Position a foot over the flat face
of the foot plate, aligning holes
in underside of the foot with the
mounting holes in the column, and
secure foot to column with four
M6 x 35 socket head cap screws.
Torque to 7.5 ft/lb (Figure 1).
4. If casters are required, twist both
adjustable glides out of the foot.
Locking and non-locking casters
are supplied. Locking casters
should be located toward the
front, user side of the table for
easy access while the non-locking
casters are located to the back.
Using four #10-24 x / " Torx
3
8
screws, carefully secure the casters
to the foot (Detail A).
5. Repeat steps 2 & 3 for second leg
assembly and step 4 if casters are
required (Figure 1).
6. Position two leg-to-leg spanners
with channel opening face up, then
slide both spanners into the open
ends of each base tube of both base
assemblies. Slide bases together,
but do not secure with set screws at
this time (Figure 1).