6. Cut the tie wraps holding the stepper
motor cables at the rear of the assembly
(Figure 6-5).
7. Remove the two mounting screws and
ground lug attaching the assembly to the
rear of the chassis.
8. Gently slide the head carriage toward
the rear of the drive.
9. Slide the assembly toward the rear of the
drive.
10. Lift up the assembly and slide it toward
the rear of the drive, and slide the front
latch out of its tracks.
CONE LEVER ASSEMBLY AND CABLE HARNESSING
11. Slide the assembly toward the rear of the
drive, tilting it until the upper arm
finger is free.
12. Remove the assembly from the drive.
REPLACEMENT
1. Route the head cable up through the
large open area of the Cone Lever
assembly.
2. Position the assembly to ensure the
upper arm finger is in place. Place the
front door latch in its tracks, and slide it
to the front of the drive.
FIGURE 6-5
6-11