7 . Associated power and interface cables.
8 . A number 1 Phillips screwdriver.
9 . A number 2 Phillips screwdriver.
10. An 0.050-inch Allen wrench.
11. A flat blade screwdriver.
12. A 5/64-inch Allen wrench.
13. A 7/64-inch Allen wrench.
FIGURE 5-1
LOGIC CIRCUIT BOARD WITH TEST POINTS
5-2
Test equipment must be in calibration. This may
be verified by observing the calibration due date
on the calibration sticker affixed to the
equipment.
5.3
POWER/DRIVE SELECT
CHECK
The drive select check verifies the activity
L.E.D. can be illuminated, and power is supplied
STEPPER
MOTOR
SERVO
JUMPER
J4
J2 POWER
CONNECTOR