Table of Contents
Advertisement
Remark: The bandwidth needed will depend on
the number of services present in the
output (those selected as ON or DCY,
see menu of services).
c. Output Menu
The following standard menu shows the output
frequency/channel, the output level control
and the output mode control.
To modify the frequency, press
desired parametre starts fl ashing. Then you can
change its value by means of keys
The output frequency range is 46 to 862 MHz
The output level control allows values between 00
and 99.
The available output values are:
• Norm
Normal Output Mode
• CW
Continuous Wave Mode. A continuous
carrier is generated in the output
frequency selected (useful for balancing
the headend in the absence of an input
signal).
• OFF No output is generated.
• NULL QAM output modulation with null
packets only.
d. Services menu
This menu shows the list of transport stream
services selected. Each time the user selects a new
input transport stream, the unit performs a search
for services.
During the process, the unit will show the message
below displaying the number of channels as soon
as they are being found:
key until the
and
.
Once the search has completed, a list of services is
displayed with the following information:
It is indicated the service order number as well
as the total number of services in the multiplex
(the fi gure indicates that the 2nd service out of
8 services, is available), the statistics (18/25) and
the service name. In the processing mode (see
Confi guration menu 2) it is shown if the user has
selected it to: either remove its encryption from
the output (OFF) by means of a module CAM (DCY),
or to pass through without modifi cation (ON).
Statistics information is the following: fi rst
number indicates the percentage of the output
occupied by the displayed service; second
number indicates the free percentage at the
output.
In the example:
• Service "La2" would occupy the 18% of the
output (since it is set OFF, means that it is being
eliminated)
• There is a 25% of free room.
• So we can easily see that, in principle, this
service could be activated (ON or DCY), since
there is still suffi cient capacity at the output.
The free capacity percentage at the output is
only updated once recorded the confi guration
of services.
15
EN
Advertisement
Table of Contents
