Operating Your Wine Cooler - Vinotemp element EL-100WBC-TS Owner's Manual

INSTALLING THE CHARCOAL FILTER
To install the charcoal filter, please follow the instructions below:
•
Replace the door gasket to its original position.
•
The back of the filter has a 3M glue tape which you can affix to the
shelf or the inside of the unit.

OPERATING YOUR WINE COOLER

The unit should be placed in a position where the ambient temperature is between 41 - 100°F and the humidity level
is between 45 -90%. If the position is above or below this range, the performance of the unit may be affected. For
example, placing your unit in extreme cold or hot conditions may cause interior temperature to fluctuate.
NOTE:
•
When you use the unit for the first time or restart the unit after having been shut off for a long time, there
could be a few degrees variance between the temperature you select and the one indicated on the LED
readout. This is normal and it is due to the length of the activation time. Once the cooler is running for a few
hours everything will be back to normal.
•
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If
you attempt to restart before this time delay, the fridge will not start.
The controls of your wine & beverage center:
A. Light
To control the inner light, turn on/off.
Press the light key once-- the blue LED light on the top will go on, press again, for it to turn off.
B. Selector
Select the temperature display setting in Fahrenheit or Celsius.
C. Set temperature
Press this button, press"+""-" key to set temperature. To view the "set "temperature at any time, press the key. The
"set" temperature will temporarily "flash" in the LED display for 5 seconds.
D. The indicator for the upper chamber.
E. Display temperature for the upper chamber.
F. Display temperature for the lower chamber.
G. The indicator for the lower chamber.
H. Up
Used to raise the set temperature by 1°C or 1°F.
I. Down
Used to lower the set temperature by 1°C or 1°F.
J. Power