Yamaha XSR900 Owner's Manual page 20

Instrument and control functions
TIP
1
If the light does not come at all, or if the
light does not go off after traveling 10
2
km/h (6 mi/h), have a Yamaha dealer
check the vehicle.
3
WARNING
4
If the ABS warning light does not go
off after traveling at a speed of 10
km/h (6 mi/h) or higher, or if the
5
warning light comes on or flashes
while riding, the brake system re-
6
verts to conventional braking. If ei-
ther of the above occurs, or if the
7
warning light does not come on at
all, use extra caution to avoid possi-
ble wheel lock during emergency
8
braking. Have a Yamaha dealer
check the brake system and electri-
9
cal circuits as soon as possible.
10
Traction control system indicator
light "TCS"
11
This indicator light will flash when trac-
tion control has engaged.
12
If the traction control system is turned
off, this indicator light will come on.
(See page 3-17.)
TIP
When the vehicle is turned on, the light
should come on for a few seconds and
then go off. If the light does not come
on, or if the light remains on, have a
EWA16041
Yamaha dealer check vehicle.
Immobilizer system indicator light
" "
When the key is turned to "OFF" and 30
seconds have passed, the indicator
light will flash steadily to indicate the im-
mobilizer system is enabled. After 24
hours have passed, the indicator light
will stop flashing, however the immobi-
lizer system is still enabled.
The electrical circuit of the indicator
light can be checked by turning the key
to "ON". The indicator light should
come on for a few seconds, and then
EAU78591
go off.
If the indicator light does not come on
initially when the key is turned to "ON",
if the indicator light remains on, or if the
indicator light flashes in a pattern (if a
problem is detected in the immobilizer
system, the immobilizer system indica-
tor light will flash in a pattern), have a
Yamaha dealer check the vehicle.
TIP
If the immobilizer system indicator light
flashes in the pattern, slowly 5 times
then quickly 2 times, this could be
caused by transponder interference. If
this occurs, try the following.
EAUM3621
1. Make sure there are no other im-
2. Use the code re-registering key to
3. If the engine starts, turn it off, and
4. If one or both of the standard keys
3-5
mobilizer keys close to the main
switch. Other immobilizer system
keys may cause signal interfer-
ence and prevent the engine from
starting.
start the engine.
try starting the engine with the
standard keys.
do not start the engine, take the
vehicle and all 3 keys to a Yamaha
dealer to have the standard keys
re-registered.