Operating The Cleaner - Samsung SR8848 User Manual

Operating the cleaner

INSTALLING THE ROBOTIC VACUUM CLEANER
INSTALLATION ORDER
1. Turning the Power Switch on or off
To use the robotic vacuum cleaner, you must turn on the Power Switch at the
bottom of the main unit.
2. Installing the Charger
To charge the robotic vacuum cleaner, you must fi rst install
the charger.
Since the battery is discharged when the product is
purchased, you must fully charge the battery before use.
3. Charging the Battery
You should charge the battery completely before using the
robotic vacuum cleaner.
4. Installing the VIRTUAL GUARD
You can confi ne the robotic vacuum cleaner to a particular
section by using Fence (virtual wall) mode or clean several
sections one by one using Guard (virtual door) mode.
TURNING THE POWER SWITCH ON OR OFF
To use the robotic vacuum cleaner, you must turn the
Power Switch on.
If you turn the Power Switch off, all settings will be reset.
1. Turn over the main unit and turn the Power
Switch on.
- If the icons are not turned on, it indicates that the
battery charge is depleted. In this case, dock the robotic
vacuum cleaner to the charger station after turning the
Power Switch on.
- Note that turning the Power Switch off will reset all
settings.
- When no key is pressed for approximately 10 minutes
when the power is on, the power is automatically turned
off to save battery power. In this case, to use this robotic
vacuum cleaner again, please push the "Power" button
or "Start/Stop" button.
If the Power Switch is turned off, the robotic vacuum cleaner will not be charged
even if it is docked with the charger station.
CAUTION
20_ Operating the cleaner