Bosch EPS 610 Original Instructions Manual page 9

2
1
Fig. 4: Movement of the swivel plate
1 Knob
2 Cam plate
3 Hose
Warning - Breakage of measuring glass
tubes
The measuring glass tubes will break if they
hit against hard objects (for eg., fixtures for
the fuel injection pump).
¶
Ensure that the measuring glass tubes
do not hit against any hard objects.
¶
Wear protective gloves.
¶
Replace broken measuring glass tubes
immediately.
During calibration of the fuel injection pump, the test oil
can be collected by orienting the measuring glasses in a
tilted position. The delivery quantity can be measured by
orienting the measuring glass tubes in a vertical position.
i
Ensure that the correct slot on the cam plate is
engaged to avoid free rotation of the swivel plate
(Fig. 1, Pos. 14).
The quantity of test oil fed into the measuring glasses is
controlled by the movement of a stroke valve. The di-
rection and movement of the stroke is governed by the
electronic control unit of the bench.
The test oil is routed back from the MGT to the tank via
the hose (Fig. 4, Pos. 3).
Bosch Limited
3
Fig. 5:
1 Bush
2 Locking screw for MGT vertical movement
3 Screws for fixing the vertical guide
The MGT is pivoted on a swing arm and can be swiv-
elled 15
(Fig. 5, Pos. 2).
i
Vertical MGT adjustment
To move the MGT vertically, loosen the screw
(Fig. 5, Pos. 2). Then, rotate the hexagon bush
(Fig. 5, Pos. 1). The MGT can traverse 150 mm vertically
to adjust the height for different lengths of high pres-
sure pipes. The swing arm can be fixed in the required
position by tightening the allen bolt on the clamping
piece
Product description | EPS 610 | 9
3
MGT height adjustment mechanism
on either side by loosening the locking screw
o
The swing arm is located under the pump mounting
bed. It can be rotated 180
be operated from either side (left hand side or right
hand side).
en
1
2
so that the EPS 610 can
o
|
F 002 DG9 918 2017-10-16