Sony BETACAM SX Operation Manual page 86

7-2 Basic Menu
Resetting the menu settings to their
factory default values (menu item B20)
6 0
SET button
1
Set menu item B20 RESET SETUP to ON.
"PUSH SET BTN" appears in the time data display
area 1 and 2, and "Push SET button" appears on
the monitor screen.
2
Press the SET button.
The current active menu settings (see page 7-8) are
reset to their factory default settings.
3
Press the SET button again.
The settings are saved and the menu display
disappears from the time data display area.
Switching between 525/625 line systems
(menu item 013)
Using the following procedure, you can set basic menu
item 013, 525/625 SYSTEM SELECT, to "ON", and
then switch between 525 (NTSC) and 625 (PAL).
..........................................................................................................................................................................................................
1) A monitor connected to the COMPOSITE VIDEO
OUTPUT 3 (SUPER) connector or the SDI OUTPUT 3
(SUPER) connector
7-6
Chapter 7 Menu System
%
9 ) p
Time data display
1
Select menu item 013.
The time data display and the monitor
show the following displays.
Time data display
Monitor screen
ITEM-013
525/625 SYSTEM
SELECT
OFF
2
Holding down the JOG button, turn the search dial
to change the setting from "OFF" to "ON".
The displays change as follows.
Time data display
Monitor screen
ITEM-013
525/625 SYSTEM
SELECT
ON
Push SET button!!
1)
screen