Frontdirectionindicators; Rearopticalunit - PIAGGIO Liberty 125 - 200 Euro 3 Manual

N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE VE-
HICLE IS USED.
03_22

Frontdirectionindicators

In order to replace the front turn indicator bulbs remove the light taking off the retaining
screws, then remove the bulb holder form its support; gently turn the bulb around 30º
and remove it. Follow the process in reverse order to refit.

Rearopticalunit (03_23)

In order to reach the rear tail light bulb remove the 2 «D» retaining screws. To gain
access to the turn indicator bulbs, remove the fastening screws «E». Remove the light
taking off the retaining screw, then remove the bulb holder form its support; press the
bulb slightly, turn it about 30° and then extract it. The bulbs have a bayonet coupling,
to remove them press gently and twist anticlockwise about 30°. To refit follow the same
steps but in reverse order.
N.B.
IF MISTING IS NOTICED ON THE INSIDE OF THE HEADLAMP GLASS, THIS
03_23
DOES NOT INDICATE A FAULT AND IS ATTRIBUTABLE TO HUMIDITY AND/OR
TO LOW TEMPERATURES.
45